DR.KDSS X TNA - BOTCK- BOLT ON TRACKBAR CORRECTION KIT (XL 6-8'')

Non kdss or kdss …. It doesn’t matter!  

Designed WITH DR.KDSS AND TOP NOTCH HAWAII for 5th gen 4runner, 4th Gen 4runner , gx 460/470 , prado 150 and fj cruiser’s WITH 6-8'' OF REAR LIFT ONLY!!!  

When you lift a solid axle that has a track bar (aka panhard bar )depending on the lift height, the angle of that trac bar  becomes so steep, that any natural cycling of the axle will cause a feeling of being unstable.  The reason for this is the trac bar being so angled, it forces the axle to swing left and right under the vehicle vs the axle cycling up and down.  

To remedy this issue, you want to raise ( or lower frame side ) the pivot point on the axle so that the trac bar is parallel or as close to parallel to the ground / axle.   With the trac bar in this configuration , the natural cycling of up and down is returned ( for the most part , once you start to add a lot more travel ie long travel , things start to swing out again.   Regardless , this will still be beneficial to having vs not having ). 

In this market, there has only really been one option for this Toyota / Lexus market.  It’s a weld on version. This new option opens up the market to allow one to easily install it themselves with simple common tools.  Not everyone has access to a welder or even access to some one that can weld.  With that said , you are still basically relying on the weld/ welder knowing what he’s doing by welding on a thicker piece of metal to the top of a thinner wall metal and In hopes of it not failing.  For the most part , it will not fail but All the load is being spread only along the weld.  

This new bolt on trac bar correction kit is designed with strength in mind.  The way it is designed, wrapped around , thick wing nut inside the oem bracket , the load is evenly distributed along the whole oem mount and not just the top where the welds are at.  On top of that you can easily toss in Some small spot welds if you are that guy that just needs it.  This thing is easily installed and or removed for whatever reason.  Just being bolted on and toque down properly, it is stronger then what’s on the market. 

Now we add color options with high end powder coating from Ablaze Powdercoating here in norco ca.   You just can’t beat this option.  

What's included :

- main front bracket  -back bracket - wing nut - (1x)m14 x 1.5 x 80mm flange head bolt - (1x) m14 x1.5 x 40mm flange head bolt - (1x) m14x35 flange head bolt - (1x) m14x1.5 flange nut - m14 washer 

15% restocking fee (no exceptions ) 

FREE SHIPPING TO HAWAII & GUAM